5 Stud wheel spacers used for Mercedes Gelandewagen
You can use these wheel spacers to push out the wheel a bit. Some people do it for the looks and others use it because they fit new rims and the new rims catches the calipers.
The wheels spacer bolts onto the vehicle on the existing studs with the nuts supplied. Your wheel then bolts onto the wheel spacer using the studs on the wheel spacer and your original nuts.
Make sure the surface on the vehicle hub is clean and free from any debris before fitment. The same applies to the back of the wheel spacer which should be clean. Tighten all nuts by hand first, then torque in cross over sequence to 30 Nm. Then Torque to 100Nm. When you have them fitted at a tyre fitment centre, keep an eye on the procedures because they normally tighten it with impact wrench. DO NOT allow them to use an impact wrench and make sure they tighten them in cross over sequence. Check the wheel spacer nuts after the first 500 km to make sure they are tight. Thereafter check every 5000km.
It will fit front and rear on auto hub models like Revo, Vigo, Prado and FJ Cruiser
NOTE: Because of the spigot ring it will NOT fit over a manual hub like on the SFA and IFS Hilux.
On SFA and IFS Hiluxes and the older Cruisers it will only fit at the rear and you will still have to fit the normal old universal 6 stud spacer at the front to go over...
Fits all Isuzu bakkies from 1972 to current
PCD = 139.7 Inner Bore = 100.1mm Thickness = 30mm - Stud = M12x1.5
Note, if you vehicle has a manual hub in front the spigot ring will not go over it.
Price per spacer
Fits Nissan Hardbody and GWM Steed
PCD = 139.7 Inner Bore = 100.1mm Thickness = 30mm Stud = M12x1.25
Note, if you vehicle has a manual hub in front the spigot ring will not go over it.
Price per spacer
The standard studs on the Toyota REVO is too short to fit wheel spacers. If you want to fit wheel spacers to a Revo you will have to replace the original studs on the vehicle with longer studs. This is what these are for. Yes, you must replace all 24x of them.
These extra studs will fit the 5 stud Land Cruiser wheel spacer - M14 x 1.5
Stud - M14x1.5mm - high tensile 12.9 grade
Nuts - 40CrMo high tensile steel
Fits all Ford Ranger and Courier models
PCD = 139.7 Inner Bore = 93.1mm Thickness = 30mm Stud = M12x1.5
Note, if you vehicle has a manual hub in front the spigot ring will not go over it.
Price per spacer
Wheel nut with Shank for Toyota Land Hilux with Aluminium rims. M12x1.5
These wheel nuts are used when you fit the standard OEM aluminium rims on a Hilux.
Length 47mm -
Wheel nut with Shank for Toyota Land Cruiser with Aluminium rims. M14x1.5
These wheel nuts are used when you fit the standard OEM aluminium rims on a Land Cruiser.
Length 47mm -